news center

Technology and formula of charcoal powder molding machine

Author (Admin) Views ( ) Posted at (2023/10/02)

 

        Carbon powder molding machine, hookah carbon tablet machine, barbecue carbon molding machine, hydraulic tablet machine, hookah carbon automatic production line, rotary tablet machine, hookah carbon molding machine, shredder, carbon powder tablet machine and other molding machine machinery and equipment.
        Use of molding machine:
        1. Before use,  cracks, deformation, loose tightness and the device is complete and in good condition.
        2. Check whether the powder of the raw material is dry and the powder content in the particle is not more than 10%. If it is unqualified, do not use it hard, otherwise it will affect the normal operation and service life of the machine and the loss of raw materials.
        3. the indicator needle of pressure regulation control should be placed at "0" position, the powder should be poured into the bucket, the hand wheel of trial run should be turned by hand, the filling and pressure should be adjusted at the same time, so as to gradually increase the weight and hardness of tablets to meet the requirements of finished products, and then the motor and clutch should be turned on first for formal operation and production, If it meets the requirements, adjust it if necessary.
        4. The choice of speed has a direct impact on the service life of the machine. Due to the fact that the viscosity of raw materials and the size and pressure of flakes can not be unified in use, the structure of the machine can be divided into fast and slow speed by means of pulley transformation. The slow speed uses the Yangtze River Delta to drive the outer pulley, which is suitable for pressing minerals, plant grass, etc. and materials that are difficult to form quickly, The short triangle is used to drive the inner rope pulley quickly, which is suitable for pressing materials with good adhesion, lubricity and easy forming, so the user can decide according to the actual situation.
        5. The manager shall be familiar with the technical performance, internal structure, operating principle of the control mechanism of the machine and shall not leave the working place during operation. In order to prevent the machine from being damaged due to failure and ensure the production.
        6. In use, pay attention to whether the sound of the machine is normal at any time. When there is a sharp sound. Do not use it reluctantly.
        Charcoal powder molding machine technology includes: adhesive formula, molding, cutting, conveying, drying and a series of technologies; This set of technology directly affects the quality and quality of charcoal products. After years of practice, our factory has summed up a complete set of technical formula.
         The characteristics of our adhesive formula are as follows:
         1. Good deashing effect;
         2. Using this agent to make charcoal powder machine-made charcoal (environmental protection charcoal, synthetic charcoal), no peculiar smell, no burst, high calorific value, no fire resistance, low ash content, combustion resistance, smooth appearance, no powder in hand, and high cold and hot mechanical strength.
         3. When the rod is pulled out, it can reach 1 meter continuously; After drying, the appearance is smooth, the powder can't be taken off by hand, and it can be broken only with a little force; When burning, it can't be scattered or broken. If it can't be burned all at once, it can be put out in water. If it can be used immediately, it can't be scattered or broken. If it can't be used continuously, its quality will remain unchanged. One ton of binder can make 20 tons of carbon powder into carbon rod. The cost of each kilogram of carbon rod is only increased by a few cents.
       Aoxing heavy industry welcome new and old friends from all walks of life to visit our factory and negotiate business
www.cnhookahcharcoal.com
Whatsapp:+0086 13849118395
e-mail：1430396450@qq.com

Pre : Basic requirements of new carbon powder forming machine for material forming
Next : Characteristics of Aoxing Heavy Industry Charcoal Forming Machine